EESS - RCM - ACMA ( Regulatory Compliance Mark)

We undertake all RCM processes for our clients including evaluation of existing test reports, testing, design for compliance, preparation of all documentation and assistance with registration on the EESS/ACMA database.

ACMA - Australian Communication and Media Authority.  This is the regulator for matters in relation to Electromagnetic Compatibility, Radio Communications, EMR (Exposure to RF fields) and Telecommunications.

EESS - Electrical Equipment Safety Scheme.  This is the scheme in place for electrical safety approvals.

There is NO connection between the ACMA and the EESS apart from the use of the RCM (regulatory compliance mark).

Step by step guidance for the ACMA's use of the RCM

Step 1.  Does your equipment contain electronic and/or electrical components?  If yes then go to step 2. If not then the ACMA's regulations do not apply.

Note that the ACMA's regulations cover electronic and electrical equipment for ALL environments.  This includes domestic, commercial, light-industry and industrial.  The ACMA's regulated environments are wider in scope than that of the EESS (see below)

Step 2.  Determine which of the mandated standards applies to the equipment.  

Step 3. Prepare a compliance folder that includes a test report, technical report, product description and photograph and a Declaration of Conformity. 

Step 4. Register as a Responsible Supplier with the ACMA and mark the product with the RCM.

Step by step guidance for the EESS use of the RCM

Step 1:  Is your equipment in scope or out of scope? 

In scope means:  

  • rated at a voltage greater than 50 V AC RMS or 120V ripple-free DC; and,
  • rated at a voltage less than 1000V AC RMS or 1500V ripple-free DC; and
  • is designed or marketed as suitable for household, personal or similar use

Out of scope means your product falls outside of these limits and definitions.  If it is out of scope go to Step 3 otherwise go to Step 2 for in scope.

Step 2:  If it is in scope first go to AS/NZS 4417.2 and find out what risk level (1,2 or 3) your equipment falls into.

https://www.eess.gov.au/wp-content/uploads/2019/04/001-EESS_In-scope-equipment-definitions-and-risk-levels-v2.0.pdf

Then go to step 2a

Step 2a: Apply the process for the risk level that applies to your equipment

  • Level 1 – Evidence of compliance with the relevant standard + (Certificate of Suitability – Optional)
  • Level 2 – Evidence of compliance with the relevant standard + Compliance Folder + (Certificate of Suitability – Optional)
  • Level 3 – Evidence of compliance with the relevant standard + Certificate of Conformity – Mandatory

Then go to step 2b

Step 2b: Register as a Responsible Supplier on the ERAC database.  Enter the information required for the risk level that applies to your equipment. Prepare a compliance folder that includes the test report, technical report, certificate of suitability or approval, product description and photographs.  Mark the product with the RCM.

https://equipment.erac.gov.au/Registration/Default.aspx

End for in scope

Step 3: If your equipment is out of scope apply AS 3820 and the applicable standard as referenced in AS 3820. Do not mark with the RCM. Do not register as a Responsible Supplier. Do make a Compliance Folder. A compliance folder contains a description of the equipment, photos and technical data including test data.

End for out of scope




© Copyright Stradia